This container is a good solution for collecting and recycling waste materials. This product is designed and built for those firms where there are thin but a long waste materials: thanks to its dimensions, the container is suitable for recovery of wooden poles and/or aluminium made profiles.
The bottom of the container is not hermetic so it can not be used where liquids waste and/or solid waste soaked in liquids are produced.
The standard container is equipped with upper openings (see figure below) suitable to move and lift the container with a forklift truck. The container can also be equipped with special hooks for lifting where insert the forks of the forklift truck (in this case there are non upper openings in the containers). The distance between the openings and/or the special hooks can be made upon customer request with no further expense.
The scraps slide down simply and easily thanks to the bottom closing plane capable to be completely opened.
The operator has to use a forklift truck to remove the material inside the container. The operator lifts the container over the collecting container and then he can easily open the bottom simply pulling the opening lever with a rope remaining in the driving seat. Then the operator can close the bottom plane and place the container to its original position always remaining in the driving seat.
|Model type||LU tot (mm)||LA tot (mm)||H tot (mm)||LU int (mm)||LA int (mm)||H int (mm)||Capacity (m3)||Mass (kg)|